Water-Save

instructions for Installation

Unscrew aerator at the end of faucet and remove any existing washer. Run water to remove trapped particles.

For faucets with female (internal) threads: Remove threaded aerator with rubber gasket at top of Water-Saver faucet. Insert adapter and rubber gasket into faucet and tighten using a quarter or similar sized coin. Screw Water-Saver faucet into adapter and tighten by hand.

Rotate Water-Saver faucet to the desired handle position. Note:The adapter must be installed separately and prior to installation of the Water-Saver faucet unit.

For faucet with male (external) threads: Remove threaded adapter and rubber gasket. Install Water-Saver faucet directly onto faucet and tighten by hand. Rotate Water-Saver faucet to the desired handle position.

Operating Instructions

After installation of the Water-Saver faucet puch handle to open positioin, adjust faucet valves to the de4sired water temperature and pressure, then release handle leaving the faucet valves at the adjusted setting.

Continuous Flow Function

To activate continuous flow function, push handle back to open position, slide locking disk up until engaged and release handle. To disengage continuousw flow funcion, push on handle and let the locking disk slide back down.

The Water-Saver faucet is designed to fit most standard U.S. faucets. If device does not fit, it may require a different sized adaptor available at most hardware store. Do not remove plastic internal cap or in any way alter device- doing so will void warranty, as will improper installation of device.

CAUTION! Buildings with recirculation systems may require installation of a check valve underneath the sink. Please consult a cerified plumber.
Handle treated with CIBA·IRAGUARD·B 1000, an antimicrobial effective against a wide range of bacteria.

CAUTION! To avoid scalding, be sure that faucet valves remain at adjusted settings.
One Year Limited Warranty on parts and components.
U.S. Patent No. 7,093,615